Youtor
>> YOUR LINK HERE: ___ http://youtube.com/watch?v=-9DYn_XPxqM
This 3D printer from Creality had a problem with the filament sensor the first time I tried to use it. I could see the blue LED light turn on and off (on if it detected filament) during my test print. When it turns off, it means it no longer detected filament, even though it was still there, and that would interrupt the print and I would get an error message asking me if I wanted to load more filament into the printer. • I figured out a way to place the level switch into a slightly different position so that the faulty mis-detections of filament in the printer had been fixed. • If you enjoyed this video and would like to make a small donation, you can buy me a coffee here at https://www.buymeacoffee.com/diyplayg... Thanks for your support!
#############################
