ToggleMomentary Push Button with Arduino Tutorial

YOUR LINK HERE:

http://youtube.com/watch?v=0T6ff2eFgn4

in this video, i have explained how to use a push button to blink an LED bulb with arduino. there are 2 ways to use a push button. toggle and momentary. • a toggle switch will turn the led on if pressed once, • and turn it off when pressed again. • a momentary button will keep the led on until the button is pressed. • and turn it of when released • we will require an arduino • push button • led bulb • 4.k7 ohm resistor • and some wires • connect a pull down resistor from -ve leg of the button to the breadboard ground • connect the breadboard ground to arduino ground • connect breadboard vcc to arduino 5v • connect signal pin after first leg of the resistor to pin 2 of the arduino • connect the led to pin 13 and ground of arduino • for momentary switch, the code is already present in arduino examples. • go to examples/digital/button • upload the code and you can control the led via the button. • pressing the button will turn the led on, and releasing it will turn it off. • in the toggle switch code, we have a variable code called status, which store the • last state of the button. • if the state is true or on, it changes it to false or off, and vice versa. • Code: https://bit.ly/3bV0As2 • • upload the code and use the button. • when the button is pressed once, the led turns on • and when the button is pressed again, the led turns off. • hope you found the tutorial useful • • Solder Iron i Use: http://bit.ly/2GSArih • Helping Hand Magnifier: http://bit.ly/2Uh11oe • arduino uno Micro USB: http://bit.ly/aRdUiNo • • also do check out these cool 3d Printers: • Creality Ender 3 pro : http://bit.ly/36m1POI • Creality CR-10s pro: http://bit.ly/2QmqU6z • #Arduino #Button #Tutorial #SuperbTech

#############################

New on site