Printing with NinjaTek Cheetah flexible filament

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=22lv5eLyFqk

I needed to use some flexible filament to print some small wheels for the BB-8 Project. I came across Ninjatek Cheetah, which is a bit harder than NinjaFlex but more friendly to work with. It came out really good! Here's my review! • Looking to buy Ninjatek Cheetah? • 3.00 mm Link (Snow White Color) • https://amzn.to/2Db2J4v • 1.75 mm Link (Snow White Color) • https://amzn.to/2TIE8cG • • Here's some of the settings I used in Cura my Ultimaker 2+ to successfully print these small tires... • CURA • Layer Height - 0.1mm • Print Speed - 10mm/s • Travel Speed - 120mm/s • Combing - All • Print Cooling - 50%, layer 1 • Retraction - Disabled • Ultimaker 2+: • Nozzle Temp - 235ºC • Buildplate Temp - 45ºC • Material Diameter - 2.9mm • Material Flow - 103% • You can buy NinjaTek Sample Splash Spools at 3DPrintNY.com if you don't need a large spool of material! Great value! • Please SUBSCRIBE to my YouTube Channel! • Also, please LIKE my FACEBOOK page at / wherenerdyiscool

#############################

New on site