Pontiac Fiero 1227730 conversion step by step how to

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=3PsSX6ClBhE

Thanks for checking out my video. This ECM upgrade was done to an 87 Fiero GT that has a 3.4 pushrod engine. This is the first time I've done this swap so I've attempted to correct any video mistakes. The 2.8 block will be slightly different. The Distributorless Ignition System was installed and the ECM was programmed with code mask $88. Yes, it can be long and dry at times but it should give you a good idea of what it takes to do the 1227730 ECM upgrade on a Fiero. Below are some timeline jumps that should take you to certain segments of the process. Here is the link to the pin out diagram. • http://www.gmtuners.com/files/Fiero_2... • *****************TIME LINE JUMPS************ • 1:53 List of parts needed for the conversion. • 8:37 Before start-up of engine with original ECM • 11:18 Starting the conversion process • 13:37 Installing the Knock Sensor • 15:17 Location of the Crank Shaft Position Sensor • 16:30 Drilling through the firewall • 17:46 Wiring for the Knock Sensor • 20:32 Wiring the Crankshaft Position Sensor • 22:07 Wiring the Distributorless Ignition System (DIS) • 23:33 Capping the old distributor hole. • 24:29 Converting the vacuum EGR to digital EGR • 27:05 Wiring the Distributorless Ignition System (DIS)-CONTINUED • 32:00 Remove Old ECM and starting the repining process • 33:28 Repinning the first Fiero clip (A B) • 49:38 Repinning the second Fiero clip (C D) • 57:59 Correcting a pinning mistake (thanks to my SPECIAL guest) • 1:06:04 Tapping into the C203 clip • 1:08:39 Wiring the EGR to the ECM (green clip) • 1:11:10 Final repining of the green clip • 1:12:22 Rewiring the EGR solenoid • 1:14:12 Wiring the digital EGR • 1:17:26 Running all the grounding wires • 1:18:04 Final wiring of the digital EGR • 1:18:44 Removing the old EGR vacuum solenoid (with help from a SPECIAL guest) • 1:20:10 Capping the old vacuum lines • 1:21:04 New DIS installed and custom made ignition wires hooked up • 1:21:46 FIRST TEST START OF THE NEW ECM CONVERSION!!

#############################

New on site