HOWTO Glue traction mats back down on your PWC Boat etc

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=4Ddl2I_NC3c

Traction mats take a real beating, they are exposed to hot, cold, nearly constant water, and wear and tear from feet, shoes, and all that can eventually loosen the adhesive used to stick those mats down. • Today we stick some back down for good! In fact, we WELD them back down! • It is removable, but usually tends to destroy the mat in doing so, but should you choose to change mats later, it is possible. • The stuff you want is DAP Weldwood in the red can, or 3M 90 spray adhesive. • Key points in video: • 0:00 Introduction • 1:38 Prep is everything, Scuff the surface • 2:20 Solvent to clean dust after you've scuffed • 2:36 Glue options • 3:21 Process begins • 4:23 Scuffed, cleaned, Glue application begins • 6:05 Apply weight to mat until glue sets • 6:30 Check for loose edges • 7:04 All done, Hit the lake! • You can get all these supplies at your local hardware store, but should you choose, here are links to purchase them online: • 80 Grit sandpaper: https://amzn.to/3fFCwuX • Acid brushes: https://amzn.to/30CrZMQ • Weldwood: https://amzn.to/3gGXf2C • 3m 90 spray adhesive: https://amzn.to/2XEnfEE • These links may be affiliate links, if you purchase from them, I may earn a small commission at no additional cost to you, that helps me fund future videos and keep making content like this!

#############################

New on site