How to use speakers in Proteus Simulator

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=4R6pX8KgyJ8

Tishitu explains • A transducer is a device that converts a signal in one form of energy to another form of energy. • Energy types include (but are not limited to) electrical, mechanical, • electromagnetic (including light), chemical, acoustic or thermal energy. • While the term transducer commonly implies the use of a sensor/detector, • any device which converts energy can be considered a transducer. • We are talking about acoustic transducer i.e. speakers • A speaker is an electroacoustic transducer that • produces sound in response to an electrical audio signal input. • Most speakers use two wiring points to connect to the source of the signal • (for example, to the audio amplifier or receiver). • This is usually done using binding posts or spring clips on the back of the enclosure. • Our simulation tool is proteus. • Proteus is software for microprocessor simulation, schematic capture, • and printed circuit board (PCB) design. • It is developed by Labcenter Electronics. • We are showing you how to connect proteus with your computer sound card. • The input signal is shown in the digital oscilloscope. • A potentiometer is use here as volume controller as it is used to adjust input signal amplitude or voltage. • TISHITU • ISO: 9001-2008 • RESEARCH AND CONSULTANCY CELL OF INDUSTRIAL APPLICATION • A Joint Accreditation System of Australia and New Zealand • Copyright © All Rights Reserved www.tishitu.org Reg No.08122629691/SSI • Accreditation No. M3111204IN • ~-~~-~~~-~~-~ • Please watch: Lifi Communication by Arduino UNO Download Project • • Lifi Communication by Arduino UNO Dow... • ~-~~-~~~-~~-~

#############################

New on site