Youtor
Model Railway Automation using JRMI Dispatcher and Simple Signal Logic
>> YOUR LINK HERE: ___ http://youtube.com/watch?v=5lvvoBCQl9U
In this video we bring to together the systems we built in the previous videos (DCC++ base station, sensor hub, block occupancy detection and servo control) to start automating a simple layout. • Links to previous videos: • DCC++ Base Station: • Model Railway Digital Controller (DCC... • Sensor Hub Part 1: • Model Railway Sensors Detection Par... • Sensor Hub Part 2: • Model Railway Sensors Detection Par... • Block Occupancy Detection: • DCC Block Occupancy Detection in JMRI... • Servos Part 1: • Servo Motor Control for Model Railway... • Servos Part 2: • Servo Motor Control for Model Railway... • Servos Part 3: • Servo Motor Control for Model Railway... • This is probably the simpliest way to implement automation using the JRMI built in tools. However, the subject of automation is vast and there are lots of ways of achieving it, this is just a demonstration of a particular set of tools in a signal piece of software. • We cover three types of automation from basic signalling that would work on an analogue layout (using appropriate block occupancy detection) under manual control to full computer automation. • 1) Simple Signal Logic - which will automatically set signal aspects based on the turnouts and blocks they protect. • 2) Using dispatcher to allocate blocks to a train and automatically set signals and turnouts along the route for us to manually drive along. • 3) Using dispatcher to take control of a train and automatically drive it between two locations whilst controlling points and signals. • Ebay and Amazon Affiliate Links • (Full disclosure, as an Amazon Associate and Ebay partner I earn from qualifying purchases through these links and this helps to support the channel) • Arduino Uno: • https://amzn.to/2ODZoTO • https://ebay.us/HYHkvP • Arduino Mega: • https://amzn.to/3poEBQK • https://ebay.us/Zl3sDT • Servo Driver Board (PCA9685): • https://amzn.to/2NoTKo3 • https://ebay.us/rVpaAJ • SG90 Servos: • https://amzn.to/2N3uzY4 • https://ebay.us/Xvuu72 • Variable Voltage Power Supply: • https://amzn.to/3b4wtj9 • IR Sensors: • https://amzn.to/2LQJmVF • https://ebay.us/rnR5wn • Servo Wires (male to male): • https://amzn.to/3alIrFS • https://ebay.us/HfgTaO • 26AWG Servo Cable: • https://amzn.to/3daEp55 • https://ebay.us/L1q3FE • Crimping Tool: • https://amzn.to/3tRJXHE • https://ebay.us/XE2Dxl • Chapters • 00:00 - Introduction • 02:47 - Steps • 03:51 - Step 1 - Setup the Layout • 06:14 - Step 2 - Setup JMRI • 18:58 - Step 3 - Simple Signal Logic (SSL) • 23:42 - Step 4 - Using Dispatcher with Manual Control • 32:24 - Step 5 - Using Dispatcher with Automated Trains • 39:49 - Conclusion
#############################
