Youtor
HOW TO INSTALL A ONE PIECE EPDM ROOF FLEXIPROOF®
>> YOUR LINK HERE: ___ http://youtube.com/watch?v=AHqjZVx3KbY
In this video tutorial, you’ll learn how to prepare your project site and correctly install a complete, simple EPDM flat roof with the FlexiProof One Piece EPDM flat roof system. • Carefully follow the steps in our video and use the right tools and materials for the very best results. Contact us with questions or to learn more about our EPDM roofing training: https://www.flexiproof.co.uk/the-epdm... • Learn more about the FlexiProof EPDM flat roof system: https://www.flexiproof.co.uk • ROOF SURFACE PREPARATION • Tools required: • • Cordless drill with countersink • • Countersunk screws • • Belt sander • • Leaf blower • No materials required • MARK THE ROOF PERIMETER AND MEMBRANE FOR CONTACT BONDING ADHESIVE APPLICATION • Tools required: • • Combination square • • Marker pen • • Heat gun • • Scribe • Materials required: • • Contact Bonding Adhesive • INSTALLING THE ONE PIECE MEMBRANE • Tools required: • • Medium pile paint roller and pole • • Broom • • Safety goggles • • Stirrer • • Mini paint roller • • Craft knife • Materials required: • • One Piece EPDM Membrane • • Water-Based Deck Adhesive • • Contact Bonding Adhesive • WEATHERING WALL TERMINATIONS • Tools required: • • Craft knife • • Tape measure • • Scribe • • Scissors • • Paint brush • • Silicone roller • • Penny roller • • Sealant gun • Materials required: • • 9 Inch Uncured Flashing Tape • • EPDM Primer • • Lap Edge Sealant • INSTALLING ROOF EDGE GUTTER TRIM • Tools required: • • Hammer • • Ringshank nails • • Mini paint roller • • PolyTop nails • Materials required: • • Lengths of Gutter Trim • • Contact Bonding Adhesive • INSTALLING ROOF EDGE RAISED KERB TRIM • Tools required: • • Fine tooth hand saw or multi cutter • • Hammer • • PolyTop nails • Materials required: • • Lengths of Raised Kerb Trim • INSTALLING ROOF EDGE CORNERS • Tools required: • • Craft knife • Materials required: • • Raised Kerb Trim External Corners • • Superglue • • Superglue activator • Things to be aware of: • • The prepared roof surface must be clean, dry, and free from dust and contaminants (bitumen, oil, etc). • • Always countersink the screw holes in the roof deck, and sand the joins, to create a flat surface to apply the One Piece EPDM membrane to. Your EPDM flat roofs will be smooth and smart!• If there are any factory or transit creases in the One Piece membrane, carefully use a heat gun to remove them. • • Always check Contact Bonding Adhesive is touch dry before applying the membrane. This will prevent any gas bubbles from forming underneath.
#############################
