Youtor
Cisco Radius Configuration on Packet Tracer
>> YOUR LINK HERE: ___ http://youtube.com/watch?v=AX9aBMp-qnk
Cisco Trainings on IPCisco.com : • https://ipcisco.com/course/ccna/ • https://ipcisco.com/course/ccnp-route/ • https://ipcisco.com/course/ccnp-switch/ • https://ipcisco.com/course/ccie/ • Cisco Hands On : https://ipcisco.com/course/cisco-hand... • Useful Pages: • PACKET TRACER FILES : https://ipcisco.com/cisco-packet-trac... • CHEAT SHEETS : https://ipcisco.com/protocol-cheat-sh... • QUIZES SECTION : https://ipcisco.com/all-quizes/ • NETWORK TOOLS : https://ipcisco.com/network-tools/ • INTERVIEW QUESTIONS : https://ipcisco.com/technical-interview/ • RADIUS Configuration on Cisco Packet Tracer, • How to Configure RADIUS on Cisco Routers • #RADIUS #TACACS #PacketTracer #CCNA #CCNP #CCENT #CCIE #RadiusServer • #ccnasecurity #cybersecurity #networksecurity • • RADIUS Configuration on Packet Tracer • • In this RADIUS Configuration Example, we will configure RADIUS Server and a Cisco Router for RADIUS Authentication, for the users connected to the router via Cisco switch. • • For out RADIUS Configuration Example, we will use the below topology on Cisco Packet Tracer. • How can we configure RADIUS? • In this RADIUS Configuration Example, we will follow some steps on RADIUS Server, Cisco Router and the PCs. These RADIUS Configuration steps are given below: • We will do the IP Configurations on both interfaces of the Router and PCs. • We will configure RADIUS Server IP Configuration. • RADIUS Settings on RADIUS Server will be configured. • Username and Password definitions will be set on RADIUS Server. • We will focus on the AAA Configurations on the router. • Laslty, we will verify our RADIUS Configuration. • RADIUS Configuration on Cisco Router • In this step, firstly, we will configure the router with “aaa new-model” command. With this command, we will say the router that, we will use RADIUS or TACACS. • After that, we will set the RADIUS Server IP address. We will do this with “ radius-server host 10.0.0.2 key abc123” command. The IP address is the IP address of our server and the key is the secret key that we have configured on RADIUS Server. • Then, we will set RADIUS as the default login mode of the router with “aaa authentication login default group radius local” command. • We will configure telnet logins with the default authentication. And save the configuration. • Router1 (config)# aaa new-model • Router1 (config)# radius-server host 10.0.0.2 key abc123 • Router1 (config)# aaa authentication login default group radius local
#############################
