DIY Raspberry Pi Arduino Plant Watering System

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=DOaDnYj3vfI

This project is an automatic plant watering system. Arduino controls the pump based on the soil moisture level read. Raspberry Pi shows you the soil moisture level through the Arduino IDE app. When the soil moisture drops below the threshold value (default 5), water is pumped through the tubing for 1 second. • Code: https://github.com/carolinedunn/Plant... • Materials: • Your potted plant. I'm using this Bonsai Tree - https://amzn.to/2CUERV4 • (It is best to start this project with dry soil.) • Arduino Uno - https://amzn.to/2VIyRW5 • 9V snap connector kit - https://amzn.to/3gsXhur • Battery and battery pack to power the pump (I'm using a 9V battery with snap-on connector and power supply module) • Male-to-Male Jumper wires - https://amzn.to/2TIyXMj • Male-to-Female Jumper wires - https://amzn.to/2TIyXMj • Breadboard - https://amzn.to/2VKjJrd • Plant watering kit: - https://amzn.to/31FSpht • Relay Module • Soil Moisture sensor (Please use a capacitive soil moisture sensor, NOT a resistive soil moisture sensor) • Water pump tubing • Small screwdriver to unscrew the relay module • Raspberry Pi 4 - https://amzn.to/2D4nm4J • microSD card formatted with Raspberry Pi OS • power supply for Raspberry Pi and Arduino (I'm using a USB-C power bank - https://amzn.to/2VZSitN ) • Container filled with water. • Casing for electronics (protect from rain) I'm using a 12x12 scrapbook case - https://www.michaels.com/12in-x-12in-... • Optional: Soldering iron, flux, and wire • Tube holder - https://github.com/carolinedunn/Plant... • https://github.com/carolinedunn/Plant...

#############################

New on site