How To Honda CRF300 Rally Nav Install with Switched Accessory Connector

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=DP5BtfX7re8

How To: Honda CRF300 Rally - Nav Install with Switched Accessory Connector • This video is the installation of a Garmin bracket so that I can use my BMW Navigator 6 on my CRF300 Rally. Everything other than the mount would be the same or similar for other Nav units, or even any other 12v accessory that is wired in using the provided Accessory Connector. • On the CRF300L the accessory connector is located in the rubber shroud behind the headlamp, which should be just about accessible without removing the headlamp. The CRF300L does not have the screen and bracket, so you'll need to find a way to mount it on the bars if you have that version of the bike. • This video shows the installation on the CRF300 Rally. • 00:00 Introduction • 01:13 Bracket assembly • 04:05 Mount installation • 05:32 Accessory connector dust cap removal • 06:02 Connector wiring • 08:49 Cable routing • 11:21 Conclusion • The parts I used are as follows. I'm sure you can also find them locally too. • (Please note that for the affiliate links that result in a purchase a small commission is paid. Best to keep you informed of that!) • Honda Accessory Connector Affiliate Link: https://www.ebay.co.uk/itm/2747258896... • Ram Bar Mount RAM-B-408-75-1U Affiliate Link: https://www.ebay.co.uk/itm/1327883996... • Ram Short Arm Affiliate Link: https://www.ebay.co.uk/itm/2937553770... • Cradle: This is a Zumo 660 Cradle, however they now appear to be sold out worldwide as the device has not been sold for some time. • If you have found this useful, please like and subscribe. • Thanks • Detailed information is available at: • https://www.honda.co.uk/motorcycles/r... • http://huntsmotorcycles.co.uk/NewBike...

#############################

New on site