How To Make An Induction Gun Bolt Heater Buster

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=F6GbesTHZLc

Link to wiring diagram STL file for 3D printing the handle: https://drive.google.com/open?id=1b8q... • Parts ordered from eBay. • Use the following lines to search for the components I used in the video: • ZVS induction heater 1000w - Induction heater with fan, 12-36VDC, 20A • Switch power supply 24v - Power supply, output 24VDC, 33A • buck converter lm2596 adjustable - Buck converter. Used to drop the voltage from 24v to 12v to drive the relay LED • 12v 40A relay - Basic automotive style 12v relay (recommend buying a 24v relay because it would eliminate the need for the buck converter. Note: if doing the aforementioned replace the • 1kohm LED resistor with a 2.2kohm resistor) • 1/2watt metal film resistor - (either 1kohm if using the 12v buck converter, OR 2.2kohm if running the LED directly from the 24v PSU) • push on-off latching switch - basic latching switch • 5mm LED mount bezel - used to mount a 5mm led to the enclosure • 5mm led red - The LED I used was rated for 3.2~3.8v and a max current of 20ma • 8GA wire - Insulated 8gauge copper wire (I used about 3meters (or 10ft) total length) • c14 socket - look for a C14 socket with an integrated fuse holder. • 5mm fiberglass sleeving - I bought sleeving with an internal diameter of 5mm. Buy about 2meters (6ft) worth (its cheap) • Split Conduit - Split cable sleeving to fit over the 8GA cables that go to the handle (20mm or bigger dia, 1.5m long) • female spade terminal crimp yellow - Used to connect the 8ga cable to the relay. • 3 core mains cable - I used less than 0.5m (1.5ft) rated for 240vac, 10amps • cable gland PG9 - quantity: 4 • Optional: • 5mm copper tube - 5mm dia, 500mm long (1.5ft) I used this to make the 2nd smaller coil in the video • Music: Say Yeah - Topher Mohr and Alex Elena: • Say Yeah – Topher Mohr and Alex Elena... • SCHEMATIX -

#############################

New on site