Motorcycle custom seat in leather Automotive upholstery

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=FKTjsNPF9xA

✅Any donation to support the channel will be much appreciated! • Paypal : [email protected] • ✅Get our courses at: https://www.cechaflo.com • --------------------------------------------------------------------------------- • This video stands out how important is the making of molds to get a tailor-made cover for a motorcycle seat. If we get a precise mold the cover should snugly fit over the foam seat with a minimum of effort. • Moreover, it is also a review of 'basic sewings and trims' we have seen on another videos. We would realize they are the same used on the most humble or luxurious seat. • The cover was thoroughly foamed with a 3 mm thick foam as a lining. An exception on top where I used a 1 cm foam for the raised channels. No sewing was used for it. To form the channels the lines on leather were 'heat pressed' onto a thick muslin fabric. To do the strong attachment I used a 'polyurethane gtransparent glue' which is mostly used by shoemakers on shoes and sports tennis manufacture. • The two 'piping trims' were done following the technique shown on former video (non-pip inside). • It also should be noted the use of a 'leather skiving machine' to ease the procedure on leather upholstery. • I hope you enjoy the video and find it useful! • Cesar

#############################

New on site