A560 Assembly

YOUR LINK HERE:

http://youtube.com/watch?v=GCSCweh4ef0

A560 Assembly steps. • 1. Install the wing • Remove the slotted fuselage vane, and then Install the wing. Insert the fuselage vane back. Press the vane to make it fit the fuselage • Finally, use four buttons to fix the wing. insert the button and rotate it 90 degrees to fix the wing. Insert the other three buttons in the same way. Press the back of the wing and insert the buttons. • 2. Connect two aileron drawbars. • Aileron drawbars are usually connected in the first hole on the outermost side of the aileron. • 3. Connect two horizontal tail support rods. • 4. Install the landing gear. • Push the landing gear back along the slot until you hear a click. • 5. Install the propeller. • Take out one propeller and one rudder band to fix the propeller. • The propeller with words should face outwards. • Insert the propeller into the nose. And connect two ends with the rudder band to fix it. • Now, Assembly is done. After assembly, we can test it. • Power on the transmitter. Install the battery on A560. Fix it. There are two ways to power up A560. One is to place A560 horizontally on the ground. Then Connect the battery, so that the self-check will be done fast. You can also hold A560 in hand. After connecting the battery, place A560 on the ground quickly. • Now place A560 on the ground and connect the battery. Wait for the selft-check. You can hear a prompt tone when the self-check is done. Push the joystick to check the control surface of aileron, elevator, rudder and throttle. All channels work well. • Hold A560 and turn it to check the gyro. After that, we can fly it. • For more details of A560: • https://www.radiolink.com/a560 • Purchase link of A560: • https://www.radiolink.com/a560_where_... • If any question about A560, please feel free to contact us via email: [email protected] • #3DFixedWing#A560#radiolink

#############################

New on site