Shapeoko Calibration











>> YOUR LINK HERE: ___ http://youtube.com/watch?v=HVRXTZdxo3E

Air cutting some calibration gcode using a custom gcode sender. • My gcode file i use for calibration is at http://bit.ly/1nGQbpL • Next on my list of things to do is some cable chains. • This is a 1m square eShapeoko using a TinyG V8 controller board (Edge 438.02), nema 23 steppers for X and Y, nema 17 for Z with an acme screw upgrade, dual Y motors, dual X rails, limit and home switches installed. • UJK T-Track • http://www.axminster.co.uk/ujk-techno... • UJK Hold Down Clamps • http://www.axminster.co.uk/ujk-techno... • • Get 2Gig plus an additional 500MB free online file storage at https://goo.gl/UC4mua when you signup for a free account AND install the dropbox app (mobile or desktop).

#############################









New on site
Content Report
Youtor.org / YTube video Downloader © 2025

created by www.youtor.org