Anycubic Kobra Small Calibration

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=HYwl5IAt0lw

My calibration routine for the Anycubic Kobra (small). • Just a quick video with the steps for calibrating the Esteps and the flow percentage. Be sure to check your wheels and belts as i show in my setup video here : • • Anycubic Kobra Unboxing and setup • Anycubic Kobra: • https://shrsl.com/3ka6h • USB Driver for the kobra: • https://drive.google.com/drive/folder... • Pronterface program: • https://www.pronterface.com/ • Point 8 cube used for flow: • https://drive.google.com/file/d/1r4CA... • Commands used in the video: • M503 -shows firmware configuration • M500 -saves changes • M92 -change Esteps • G91 -relative mode for estep test • G90 -return to nromal mode (starting a print or cycling power resets) • G1 E100 F60 -extrude 100mm slowly • StudioZombie3D Various links: • https://linktr.ee/Zombiej79 • / zombiej79_3d • / will.zoobkoff • https://vm.tiktok.com/ZMLsvq3Rh • / studiozombie3d • Studio Inquries: • [email protected]

#############################

New on site