How to Make Your Own LED Light Bar Wiring Harness DIY

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=K-lDO535Tlo

DIY Light Bar Wiring Harness • In this Titan Tutorials video we're going to show you how to build your own wiring harness for your LED lightbars. In this application we'll be building for two 7inch light bars. You can use the same process and procedure for cube lights or pod lights. • To build it you will need one relay, an inline fuse, a switch, and the appropriate gauge wire for your accessories. • Everything you need: • SOLCO 7 Inch 36W LED Light Bar - https://amzn.to/2Y4DVCS • IRWIN VISE-GRIP Multi-Tool Wire Stripper/Crimper/Cutter - https://amzn.to/2WlWLVv • 3 Pin toggle Switch - https://amzn.to/2WlKpNb • 14 Gauge Red Black Wire - https://amzn.to/2PJbXtz • 14 Gauge Green Wire - https://amzn.to/2DMmRKj • Female Nylon Disconnect Spade Terminal, 16-14 Gauge - https://amzn.to/2DO9JEj • • Terminal Ring Connector 16/14 Gauge - https://amzn.to/2DMmRKj • Gardner Bender Butt Splice Terminal 16-14 Gauge https://amzn.to/2XYS98e • 12v 30A Relay - https://amzn.to/2LmKbVb • Nilight Inline Fuse Holder - https://amzn.to/2DObhhB • Visit us online at www.nissantitanaccessories.com and don't forget to like our facebook page / nissantitantutorials • This video is provided for informational purposes. Installing any mechanical components or electrical components on your vehicle without the oversight of a mechanic or electrician can be dangerous. Doing so is done at your own risk.

#############################

New on site