How to Install a New Outlet Through Junction Box

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=MQR_uFK93Mk

#outlet #electrical #DIY • How install a new outlet using an existing junction box. For parts, you'll need a TR (tamper resistant) outlet (15A for 15A circuit breaker, 20A for 20A circuit breaker), ground wire nuts, wire nuts, outlet cover, NM cable clamp, 14AWG 3 conductor or 12AWG 3 conductor cable (14/2, 12/2 Romex), old work box, and fire blocking foam/sealant. • Klein Multimeter: • https://amzn.to/2XTBmId • Klein Receptacle Tester: • https://amzn.to/2Y2D0lX • Klein Multimeter, tester, and non-contact probe combo: • https://amzn.to/2SukMc7 • Klein Wire Stripper: • https://amzn.to/2K0EXuq • Great Stuff Fireblock: • https://amzn.to/2y2CUQQ • Disclaimer: • Due to factors beyond the control of Bozo Does It, there is no guarantee against improper use or unauthorized modifications of this information. Bozo Does It assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Due to factors beyond the control of Bozo Does It, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Bozo Does It. Always follow local codes and regulations, including but not limited to NFPA, NEC, and UL standards. • Disclaimer II: • I'm an Amazon affiliate. _ • _ • If you found this video valuable and wish to support the channel, below is my Amazon affiliate page. By purchasing anything through this link, I will receive commission at no extra cost to you. Thank you! • https://www.amazon.com/b?_encoding=UT...

#############################

New on site