Bad Push Stick Design Almost Caused a Table Saw Kickback

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=OhBsM4VtHhQ

I tried to make a thin rip push stick for my table saw based on an old design in an out of print magazine. It did not go well. But I think I fixed it and made it much safer to use. Check it out! Amazon and other affiliate links are used in this description and they help support this channel. • Videos To Watch Next • How to Make a Table Saw Sled - • I Built a SAFER Cross-Cut Sled (INCRE... • How to Build a Miter Station - • How to Build a Space Saving Miter Saw... • Build Plans: https://www.731woodworks.com/store • Greatest Free Gift: http://story4.us/731Woodworks • Products I Use and Recommend • MicroJig Gripper - https://lddy.no/1cj2c • Use code 731MICROJIG10 to save 10% Off • Table Saw Blade I Use https://lddy.no/1cj2e • Use code 731CMT10 to save 10% on CMT Blades • Outlaw's Board Butter - https://www.731woodworks.com/store/bo... • Blaster Dry Lube for Table Saw - https://amzn.to/3pwFF7C • Little Red Delve Square - https://amzn.to/3T4FwpG • Favorite Tape Measure - https://amzn.to/3A9jnxF • My Table Saw - https://amzn.to/3T6J9LU • My Bandsaw - https://amzn.to/3K8ZATv • Join this channels membership to get access to exclusive member only livestreams, discounts, and other perks: • / @731woodworks • You can support us on Patreon as well / 731woodworks • I get my stickers from Sticker Mule: https://www.stickermule.com/unlock?re...

#############################

New on site