Remington Powder Actuated Fastening Tool Shot Strength Test

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=Oq-sGLg2MvE

MY MISTAKE I LOAD IT FIRST AND INSERT NAIL LATER VERY DANGERIOUS • Powder Actuated Fastening Tool Shot Strength Test video is about Performing a shot strength test on a powder-actuated fastening tool is an important safety step to ensure that the tool is functioning properly and is safe to use. Here are the steps to perform a shot strength test on a powder-actuated fastening tool: Remington 476 • Check the tool: Make sure the tool is clean and in good working order before performing the shot strength test. Also, check that the correct powder load and fastener size are being used. • Prepare the test material: Set up a piece of test material, such as a piece of wood or concrete, in a secure location. Ensure that the test material is the same thickness as the material being fastened. • Load the tool: Load the tool with a powder load and a fastener of the appropriate size and type for the test material. • Test fire the tool: Fire the tool into the test material at a safe distance. Inspect the resulting hole to ensure that it is the correct size and depth for the fastener being used. • Measure the embedment depth: Use a caliper or depth gauge to measure the depth of the hole that was created by the fastener. Compare this measurement to the recommended embedment depth for the fastener being used. If the depth is too shallow or too deep, adjust the tool or the fastener as necessary. • Inspect the fastener: Examine the fastener to ensure that it has been properly driven and that the head is flush with the surface of the test material. Check for any signs of damage or deformation to the fastener or the tool. • Repeat the test: Perform the shot strength test on several more test materials, using different powder loads and fasteners to test the range of the tool's capabilities. • By following these steps, you can perform a shot strength test on a powder-actuated fastening tool to ensure that it is functioning properly and is safe to use. Be sure to follow all safety guidelines and instructions provided by the tool manufacturer, and wear appropriate personal protective equipment during the testing process. • #bababuilder i am comparing green shot with yellow shot and see result Ramset Remington • Uses .22 caliber low velocity power loads to fasten up to 2-1/2 power fasteners • The strike of a hammer will actuate and fire a pin into concrete, steel or masonry. • Ideal for mounting framing lumber, electrical junction boxes, conduit clips, mor • powder actuated nail gun • Remington Powder actuated nailer Fastening Tool green vs yellow shot

#############################

New on site