How to Replace the Impeller on Flygt N 3127 Pumps with Adaptive N® Impeller

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=P6sizgOQudY

This is an informational video on impeller replacement for the Flygt N 3127 pump, featuring an Adaptive N impeller. This video is intended as a general reference for technical personnel tasked with maintaining pump performance and ensuring the replacement process is done safely and effectively. This video is NOT intended to serve as a step-by-step, fail-safe checklist. Projects vary and may require additional steps provided for in the Manual that are not included in this video. • • The video demonstrates the disassembly and reassembly of the impeller and pump housing, including cleaning, adjusting, and securing the components. • • For more resources and detailed information about the pump: • https://www.xylem.com/en-us/products-... • Contact us here: https://www.xylem.com/en-us/brands/fl... • Subscribe to our channel for more insights on how our innovative solutions are transforming water and wastewater management. • • Disclaimer Warning: • Carefully review the product specific Installation, Operation and Maintenance manual (“Manual”) before tampering with the product in any way. • All user safety rules and instructions contained in the Manual, as well as any other applicable safety rules, must be observed. • This video is provided as general reference only, as a complement to the Manual, and cannot be relied upon as a substitute for professional advice. • Failure to follow all instructions in the Manual may void the manufacturer's warranty. • If there is a question or any uncertainty regarding the intended use or maintenance of the equipment, contact a Xylem representative before proceeding. • Xylem cannot be held responsible for any actions or inactions undertaken as a result hereof. • 00:00-00.14 Introduction • 00:14-00:24 Lay the Pump on Its Side • 00:24-00:35 Remove the Impeller Plug • 00:35-00:51 Loosen the Impeller Screw • 00:51-01:13 Lift Pump Remove Pump Housing Screws • 01:13-01:32 Lift Pump and Lay on Its Side • 01:32-01:44 Remove the Impeller Screw • 01:44-02:05 Remove the Impeller • 02:05-02:24 Clean and Fit the Ring • 02:24-02:37 Mount the Parallel Key • 02:37-02:48 Grease the Shaft • 02:48-03:00 Fit Adjustment Washers • 3:00-03:15 Mount the Impeller • 03:15-03:46 Impeller and Washers • 03:40-04:09 Fit the Pump into Pump Housing • 04:09-04:59 Measure Clearance • 04:59-05:15 Tighten Impeller Screw • 05:15-05:35 Fit Lubricated Plug • 05:35-06:02 Check Impeller • #Flygt #ServiceVideos

#############################

New on site