Rex RX607Z Sailrite LSZ1 Clone Walking and Pressing Foot Troubleshooting

YOUR LINK HERE:

http://youtube.com/watch?v=PGqJ4ggPx-M

To quote Matt from Sailrite: • http://forum.sailrite.com/walking-foo... • The center foot will rise depending upon the lift of the outer foot. The outer foot being the walking foot. So when the feet are down the way to check this is to rotate the flywheel until the walking foot is at its highest position. Stop at this point and measure the gap under the foot (bottom of walking foot to top of needle plate). The gap should be 3mm. If it is not then you need to raise or lower the walking foot accordingly. Make this adjustment by removing the side end cover and locating the two screw clamp at about the mid point of the walking foot vertical shaft. The screws are 3mm head allens and they face the rear of the machine. After the gap is set properly you will notice that the center presser foot will rise about 1 to 2 mm when the walking foot is in its furthest downward movement. • So the key statement here is that the feet work off of one another. • Thanks, Matt • Sailrite • Also relevant reading here: • http://forum.sailrite.com/ls1-foot-he... • • Setting Foot Height Range of Motion...

#############################

New on site