DIY Extreme Outdoor Pullup Bar

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=S1lEjdXfoVE

For more follow me on: • / extremistpullup • / extremistpullup • Consider this less permanent out door pullup bar first. By homemademodern • • Building an Outdoor Pull-Up Bar | DIY... • • THE FLANGES: • The flangs and pipe are threaded. • 1. Put the flange in a vice and forced the pipe on the non lip side. (backwards). Leave the flang on the bar. You can tack weld if desired. • 2. Force the other flange on (backwards), then remove flange. this will help screwing it on later • OR • If you you can't screw the flang on backwards it will screw on the correct way (lip side in). • Sink a slightly wider hole to accommodate the lip (1/4 inch) in the wood. Then Sink a hole for the pipe all the way through the wood. • You may need to improvise or modify these plans, be creative. • Share what you have done diffrently in the comments. • Thanks • Steven • This is what happens if you dont drill a hole and mount it to the inside of the posts. • http://dailyvdo.com/mobile/watch.php?... • • Thanks for the likes! dont forget to subscribe. • Pull up bar supplies • Two 4x6 x 10ft 37.14 • One 1 x 72 Gas Pipe 22.48 • Three 50 lb Quikrete 14.94 • Two 1 inch floor Flanges 19.92 • One can Paint 3.98 • One 1 3/8 Steel Flat Bit 5.65 • Eight 2 inch x 1/4 bolts washers 3.12 • Total: 107.23 • I recommended a drill guide 29.96 • Follow me on: • / extremistpullup • / extremistpullup

#############################

New on site