How to Install StormShield Garage Door Threshold Weather Seal

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=T7gOv-hhfG4

Find Action Industries Storm Shield garage door threshold kits in three lengths at North Shore Commercial Door .com. This Storm Shield garage door threshold kit includes a threshold weather seal plus a 6-ounce tube of adhesive caulk to secure it to the floor directly beneath your garage door. The seal will stop rodents, bugs, drafts, rain and other contaminants from entering your garage. It's easy to install; just measure for the length you want, place and secure to the garage floor. • https://www.northshorecommercialdoor.... • Order a 10-ft, 16-ft or 20-ft length. Each has been tested to ensure it won't crack or break into pieces when a vehicle drives over the threshold strip. It also can withstand extreme temperatures from -40 degrees Fahrenheit to 150 degrees Fahrenheit. This garage door weather seal also meets California Fire Marshal and CPAI-84 requirements for flame resistance. Order the Action Industries SS010-10-X threshold kit if you want a 10-ft. threshold seal. Order SS016-16-X for a 16-ft. storm shield threshold kit. For a 20-ft. strip, order SS020-20-X. An instruction manual is included with each threshold plus adhesive. • OPTIONS ORDERING INFORMATION • The Storm Shield Kit is available to order in 10', 16', or 20' sections. To place your order, please select one of the following options from the drop-down menu above: • SS010-10-X 10-ft Storm Shield Kit • SS016-16-X 16-ft Storm Shield Kit • SS020-20-X 20-ft Storm Shield Kit • PRODUCT HIGHLIGHTS • Item Numbers: • 10' StormShield Kit - SS010-10-X • 16' StormShield Kit - SS016-16-X • 20' StormShield Kit - SS020-20-X • Installs easily with provided adhesive and instruction manual • Ideal for any climate and remains flexible from -40ºF to 150ºF • Meets California Fire Marshal and CPAI-84 requirements for flame resistance • Comes with a full 2-year residential warranty • Installation Instructions for Garage Door Threshold Weather Seal Kit: • With the garage door open, center the threshold between the garage door track (the channel the door rollers ride in). Trim to length with a utility knife. (The “hump” side should be on the inside side of the door.) • Lower the garage door on top of the threshold’s 2-inch level strip. Push the 45º hump against the back of the bottom of the garage door. • NOTE: Notch threshold around door jambs, if necessary, to ensure the 45º hump is against the back of the bottom of the garage door. • With the pencil, mark the inside edges of the threshold on the floor the full length of the threshold (from one door jamb to the other). • Carefully raise the door (without moving the threshold) and mark the outside edge of the threshold the length of the door. • Remove the threshold and apply three rows of adhesive the full length of the door between the pencil lines. • Replace the threshold between the pencil lines and firmly press into place. Carefully apply pressure to the threshold to ensure the adhesive spreads uniformly. • Inspect the threshold to make sure it is still between the pencil lines. The position can slightly be adjusted for a short period of time. The length of time varies depending on ambient conditions. • Close the garage door to keep constant pressure on the threshold for twenty-four (24) hours. ALLOW AT LEAST 24 HOURS FOR ADHESIVE TO DRY BEFORE DRIVING OVER.

#############################

New on site