How To Program A Beninca TOGO 2 To A Control Panel

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=TPE6dBF6IsE

To program a TO GO 2 or TO GO 4 rolling code transmitter to a Beninca Brainy electric gate control panel just follow the steps below - • Remove the cover of the electric gate control panel. • In the top right hand corner should be a LCD screen with three buttons to the right hand side. • The top button is + • The middle button is OK • The bottom button is - • Press the OK button (should now say PAR) • Press the bottom button - twice (should now say (RAd) • Press the OK button and the LCD screen should say PP • Press the OK button once and the LCD screen should say PUSH • Press the button on your remote that you wish to use • The LCD screen will flash OK and then go to PP • If you want to program further gate remotes press OK at this point and follow the last three steps again • To exit the menu press the + - at the same time until the screen goes blank, alternatively the programming will timeout after a few minutes • Once the screen has gone blank you can test the electric gate remote, which won't work in programming mode. • For electric gate installation and repairs visit http://www.yorkshireautomatedgates.co.uk

#############################

New on site