Youtor
12 f150 driver seat motor replace help hint
>> YOUR LINK HERE: ___ http://youtube.com/watch?v=TljEloHs28E
12' F150 • Parts • 1x. seat track motor • needed other tools including... • specialty tools • low profile ratchet • https://www.oreillyauto.com/detail/b/... • low profile torq sockets • https://www.oreillyauto.com/detail/b/... • Driver seat motor w/bracket replace • Start by making sure you have the correct part. After you have the part you are going to start by removing the positive and negative battery cables. • Followed by removing the 2 rear trims on the bottom of the seat. Then remove the the 4x 15mm bolts holding the seat down. After that tilt the seat back to get under and remove the clip on the large connector under front of seat. Remove the wiring clips, *note their locations (2 of the clips are the same) You'll need to remove the trim coving the seatbelt, on the seat, and remove the t50 torq on the seatbelt. • Part 2 • After you remove the seat there are clips holding the seat cover on the seat, remove those, all 4 sides. After that remove the 5 coils by removing the 25 torq bolts on the large silver plate witch will loosen the coils-for easy removal, note how they are removed the large plate will have a small t20 torq screw/bolt on a little mettle bar, note location of screw/bolt after removing bolt remove the silver plate. You'll need to remove a 13mm nut and t30 torq on front both, then lift the seat to give you the room to get to all 4x t45 bolts, to remove the motor rail. Replace the motor by pulling out the rods into the seat, and replace everything, go through the process backwards to re-install everything. • • Disclaimer: • Due to factors beyond the control of Outlaw Bilt, I cannot guarantee against improper use or unauthorized modifications of this information. Outlaw Bilt assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Outlaw Bilt recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Outlaw Bilt, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Outlaw Bilt.
#############################
