Water Heater Pilot Light Keeps Going Out Honeywell Valve
>> YOUR LINK HERE: ___ http://youtube.com/watch?v=V3AqU5-CJsg
WARNING: • DO NOT SET VALVE TO A, B, C, or VERY HOT! • Honeywell Valve has detected a“water too hot” event, the gas valve will never work again — unless you know how to reset it , the HONEYWELL FRANKENVALVE! Here is the simple fix. I opened the cover again, left everything plugged in, took a piece of speaker wire with the plastic off of the ends, and held the wire ends to the top left pin and the top-right pin for a few seconds. I saw that the light went out and the pilot had gone out. I closed the cover again and lit the pilot again. Now the light changed from flashing 4 times to flashing 7 times. This time I left the knob in the pilot position for 10 minutes. When I came back to check the water heater, I saw that the light was flashing normally. I turned the knob to just the Hot setting and it fired up! MY CHOICE / NOW, WHAT'S YOURS? Please Subscribe, Like, and Share my Videos. • #GasWaterHeater #Honeywell #WaterHeaterValve • Gas Water Heater: • • Links: http://www.tylertork.com/qna/2013/gas... • • Do the valves look about right? On the 40 50 gal Heaters Below? • 40 gal. Residential Gas Water: • https://amzn.to/2ECYT6Z • 50 gal. Residential Gas Water: • https://amzn.to/2pYPPzg • • Water Heater Control Valve : • https://amzn.to/2QKmBDk • https://amzn.to/2QoBo72 • https://amzn.to/2C6Wy0T • https://amzn.to/2EgWRb2 • https://amzn.to/2EgUpkx • https://amzn.to/2QSfTLC • https://amzn.to/2QM164Z • https://amzn.to/2QIuvgr • 📊 Robinhood Free Stock: • https://join.robinhood.com/ralphc473 • 📉 Webull Free Stock: • https://act.webull.com/t/ikCEAz9mKlh7... • 📈 Acorns: • https://www.acorns.com/invite/58XBDB • Disclaimers: all opinions are my own, sponsors are acknowledged. Links in the description are typically affiliate links that let you help support the channel at no extra cost.
#############################
