Youtor
Setting Up Arduino for programming an AtTiny85 Microcontroller
>> YOUR LINK HERE: ___ http://youtube.com/watch?v=W5bPBm6gTh8
In this video we will prepare and setup the Arduino IDE for programming the ATtiny85 microcontroller. • Both the stand-alone chip and the DigiSpark board version using the 2023 Arduino IDE version 2.1. • Feel free to ask any questions, I will answer them in the comment section. • URLs and links used in the Video using Arduino Nano: • 1. Download and install the Arduino 2 IDE: https://www.arduino.cc/en/software • 2. AtTiny85 boards: https://www.aliexpress.us/item/325680... • 3. Board manager URL: https://raw.githubusercontent.com/dam... • AtTiny Wiring Guide: • AtTiny Pin Nano Pin • 8 - VCC 5V • 4 - GND Gnd • 7 - PB2 D13 • 6 - PB1 D12 • 5 - PB0 D11 • 1 - PB5 D10 • Links and URLs Using DigiSpark board: • 1. Digistump Driver: https://github.com/digistump/Digistum... • 2. Board Manager URL: https://raw.githubusercontent.com/dig... • Chapters: • 0:00 Intro • 10:08 Wiring Guide • 12:57 Wiring Schematic • 14:50 Arduino IDE • 15:50 Source of AtTiny boards • 19:00 Updating the Arduino Board Manager URLs • 23:15 Load, Edit and Upload the ArduinoISP code to the Nano • 26:00 AtTiny Test Code Description • 29:00 Upload Test Code to the AtTiny85 • 30:00 Mention of the error: A programmer is required to Upload and work-around. • 31:34 Burn the Boot Loader to the AtTiny85 • 33:16 Run the AtTiny Test Code using the AtTiny85 on a breadboard. • 35:29 Using a DigiSpark Board for programming the AtTiny85. • 36:33 Download and Instal the DigiStump driver • 38:22 DigiStump COM port • 39:01 Install the DigiSpark Board Manager URL • 40:48 Upload the Test Code to the DigiSpark AtTiny85 • 43:05 Run the Test Code
#############################
