How to Replace a Kenmore Upright Freezer Electronic Control Board

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=X9mSqonwpgk

This video from Sears PartsDirect shows how to replace a broken electronic control board in some Kenmore freezers. If your freezer has erratic temperatures, you might need to replace the electronic control board. • Visit us at https://www.searspartsdirect.com?sid=soc:youtube:how-to-replace-a-kenmore-freezer-electronic-control-board • Or call 1-800-437-1673 to speak with a parts specialist. • The video includes these parts. Look up your model to make sure you get the right parts for your freezer. • Electronic control board • https://www.searspartsdirect.com/part... • Find parts for your freezer at: • https://www.searspartsdirect.com/part... • Or click here to schedule an appointment with a repair technician. • https://www.searshomeservices.com/rep... • Transcript: • The electronic control board controls the compressor to maintain the freezer temperature. A defective control can cause erratic freezer temperatures. If the electronic control board is defective, follow the steps in this video to replace it. Before you begin, wear work gloves to protect your hands. Unplug the freezer or shut off the circuit breaker for the freezer. Remove the screws holding the grill at the base of the freezer and pull the grill off. Move the freezer away from the wall. Remove the screws from the back cover and pull it off. Sharp, crimped tubing is exposed in the machine compartment. Place tape over the tips to protect your arms before reaching inside. Remove the screw from the electronic control board cover. Pull out the electronic control board cover and push it through the grill opening. Release the wire harness latch on the notch in the electronic control board cover. Disconnect the wires from the electronic control board. Pull the old control board out of the cover. Push the new electronic control board into the cover and snap it into place. Connect the wires to the new control board. Secure the wire harness in the notch of the control board. Push the electronic control board and cover back into the bottom of the cabinet through the grill opening. Mount the control board cover to the base of the freezer. Place the rear machine compartment cover on the back of the freezer and reinstall the mounting screws. Reinstall the front grill. Plug in the freezer or turn on the house circuit breaker to restore power.

#############################

New on site