MercedesBenz W211 EClass Crankshaft Position Sensor Replacement

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=_ZudPYH-Vy8

A crankshaft position sensor is an electronic device used to monitor the position or rotational speed of the crankshaft. The crankshaft position sensor is used to synchronize engine timing for fuel and ignition control. • The crankshaft position sensor takes the place of distributors on earlier engines. • The crank sensor is used in conjunction with a camshaft position sensor to monitor the relationship between the pistons and valves in the engine. This method is also used to synchronize a four-stroke engine upon starting, allowing the management system to know when to inject the fuel and into which cylinder. It is also commonly used as the primary source for the measurement of engine speed in revolutions per minute (RPM). • It is located on the left rear of the engine, mounted in the transmission bell housing. The sensor reads a toothed reluctor wheel mounted to the end of the flex-plate or flywheel. It then sends a signal to the DME used to identify cylinder location. If this signal is missing, for example from a faulty crankshaft sensor, the engine will not start. You can consider the signal from the crankshaft sensor the RPM signal for the DME. • In this article, I'll go over the steps involved with replacing the crankshaft position sensor. You can access the sensor from above the vehicle, working on the left side. For information on testing the crankshaft position sensor, see our tech article called crankshaft position sensor testing. • Remember your car may have been serviced before and parts replaced with different size fasteners used in the replacement. The sizes of the nuts and bolts we give may be different from what you have so be prepared with different size sockets and wrenches. • Protect your eyes, hands and body from fluids, dust and debris while working on your vehicle. If working with the electrical system, disconnect the battery before beginning. Always catch fluids in appropriate containers and properly dispose of any fluid waste. Recycle parts, packaging and fluids when possible. Never work on your vehicle if you feel the task is beyond your ability. • Read the Full Article: • https://www.pelicanparts.com/techarti... • Time: 2 hours • Tab: $130 • Tools: Set of sockets:https://www.pelicanparts.com/Mercedes..., E8, flathead screwdriver:https://www.pelicanparts.com/Mercedes... • Applicable Models: Mercedes-Benz E320 (2003-05):https://www.pelicanparts.com/catalog/... • Parts Required: Crankshaft position sensor:https://www.pelicanparts.com/catalog/... • Hot Tip: Work with a cool engine • Performance Gain: Car will start and run well • Complementary Modification: Replace air filter:https://www.pelicanparts.com/techarti...

#############################

New on site