Introduction to the Anycubic Slicer

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=a-gk6cxONBs

This video covers an introduction to the Anycubic Slicer with an explanation of settings ive found useful. Overall, I have to say the Anycubic Slicer is pretty OK. Remote print is a love hate relationship, but also the reason I keep coming back. • 00:00 Intro, build plate and volume • 01:30 Orientation, scaling, cutting objects • 08:36 Paint on Supports (better than auto generate) • 14:02 Print Settings - Layers and perimeters • 22:32 Avoid knocking off supports - Z-Hop and retraction • 26:42 Print Settings - Back to layers and perimeters • 32:49 Print Settings - Infill • 37:50 Print Settings - Skirts and brim • 42:55 Print Settings - Support material • 49:56 Print Settings - Speed • 54:30 Print Settings - Advanced • 56:08 Filament - Filament settings • 58:15 Filament - Filament settings - Pressure advance • 01:02:56 Filament - Cooling, advanced, retraction • 01:03:48 A note on saving settings • 01:04:46 Printer - General • 01:06:30 Printer - Machine limits • 01:08:38 Printer - G-Code • 01:15:25 Remote Printing • 01:18:37 Settings montage • Scraper shown in the video : https://makerworld.com/en/models/1295... • 8080 Extrusions shown in the video : https://www.printables.com/model/7557... • Start G-Code I use : • • G90 ; use absolute coordinates • M83 ; extruder relative mode • M140 S[first_layer_bed_temperature] ; set bed temp • M190 S[first_layer_bed_temperature] ; wait for bed temp • M104 S180 ; warmer extruder temp • M107 ; Set Fan Off • G28 ; move X/Y/Z to min endstops • M420 S1 ; load mesh • G1 Z0.28 ; lift nozzle a bit • G92 E0 • G1 Y3 F2400 ; zero the extruded length • M104 S[first_layer_temperature] ; set extruder temp • M109 S[first_layer_temperature] ; wait for extruder temp • G1 X180 E40 F500 ; Extrude 25mm of filament in a 5cm line. • G92 E0 ; zero the extruded length again • G1 E-0.2 F3000 ; Retract a little • G1 X181 F4000 ; Quickly wipe away from the filament line • M117

#############################

New on site