How To Make MiterBevel joints that arent 90 degrees Woodworking Tips

YOUR LINK HERE:

http://youtube.com/watch?v=a9DqdPI0c5s

▸ Support the Show on Patreon - https://goo.gl/w3pg2j • In this woodworking tip video I show how to make miters and bevels on a table saw that aren't 90 degrees. I guess technically these are bevels...but people commonly refer to them as miters, so I'm sticking with it. I can't remember where I learned this trick but I use it quite a bit. The cool thing about it is that it takes a lot of the human error out of trying to perfectly dial in 2 different angles on your saw. It also allows you to make cuts that wouldn't be possible normally, as running the piece horizontally and vertically provides the same functionality as a saw that could tilt 90 degrees, instead of the normal 45. • ---------------------------- TOOLS ---------------------------- • Incra T-Rule (the marking square thing) - http://amzn.to/2mgnSDi • ---------------------------- LINKS ---------------------------- • Subscribe --- https://goo.gl/oVdN4f • Patreon --- / chrissalomone • Instagram --- / foureyesfurniture • Twitter --- / _foureyes • Facebook --- / foureyesfurniture • Google+ --- https://plus.google.com/1157647917329... • Web --- http://www.foureyesfurniture.com/ • Music by Chris Jon Johnson. Check him out on bandcamp.com under the name Sleepy Pablo . • Link - https://sleepypablo.bandcamp.com/

#############################

New on site