Install a Filament Runout Sensor on your 3D Printer and Klipper

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=bgfuH7Ktyk0

Learn how to install a filament runout sensor and configure Klipper to make use of the Trianglelab filament runout sensor and never loose a 3d print again to runout. • Note, please don't risk blowing your electronics and don't plug devices into a powered circuit board like I did, by mistake, in this video! • This video should also be applicable for 3d printing beginners that are interested in upgrading their 1st 3d printer. • • The run out sensor can be purchased at Amazon where I receive a commission that directly contributes to content creation on this site: • https://amzn.to/40IJTZX • The military green ABS and black ASA filament: https://www.paramount-3d.com/?ref=o45... • Important links: • Base script: file:///home/harry/Downloads/filament_runout_detection.cfg • STL file: https://github.com/VoronDesign/VoronU... • Fysetc Spider pinouts: https://wiki.fysetc.com/images/Spider... • My modified script used in the video: • [filament_switch_sensor RunoutSensor] • switch_pin: !PB13 # Pin ESTOP-Y for Spider mcu • pause_on_runout: false • runout_gcode: M600 # Move nozzle to a location thats easy for the user to access • ##################################################################### • Filament change macro M600 • ##################################################################### • [gcode_macro M600] • variable_park_x: 175 # try half your bed size. • variable_park_y: 10 • variable_z_lift: 50 • variable_velocity: 60 • variable_retract: 0.5 • gcode: • SAVE_GCODE_STATE NAME=STATE_M600 # remembers the position • • PAUSE_BASE • Fluidd redifines PAUSE to move the the back corner of the printer. We don't want that. This is what Fluidd renamed basic pause to. • Mainsail renames PAUSE to BASE_PAUSE , so you should probably use that instead. If using other software, probably just use PAUSE. • • safe park coords • {% set th = printer.toolhead %} • {% set park_x = [params.X|default(park_x)|int, th.axis_maximum.x-2]|min %} • {% set park_y = [params.Y|default(park_y)|int, th.axis_maximum.y-10]|min %} • {% set park_z = [th.position.z + params.Z_LIFT|default(z_lift)|int, th.axis_maximum.z]|min %} • {% set park_feedrate = params.VELOCITY|default(velocity)|int * 60 %} • • retract at 50mm/sec • G91 • G1 E-{retract} F3000 • • park toolhead • G90 • G0 X{park_x} Y{park_y} Z{park_z} F{park_feedrate} • • Tell user to reload filament • M117 Reload Filament • • RESTORE_GCODE_STATE NAME=STATE_M600 • End of gcode script • Thank you for watching! • Please subscribe today! • Instagram: / kapmansbasementworkshop

#############################

New on site