Youtor
9 BRAD NAIL MISTAKES and how to avoid them
>> YOUR LINK HERE: ___ http://youtube.com/watch?v=cqpIJCCxxnA
Check Out Our FREE GUIDE: 25 Must-Have Carpentry Tools...Under $25 Each! • https://www.thehonestcarpenter.com/ • Tool Affiliate Links Below: • PORTER CABLE 18ga BRAD NAILER: • https://amzn.to/306C8Af • Dewalt 18ga Brad Nailer (highest sales ranking in class): • https://amzn.to/3belk0r • Dewalt 2.5 Gal Quiet Trim Compressor: • https://amzn.to/3sQmLbo • Wen 18ga Brad Nailer w/ Nails (BEST COST/VALUE ON AMAZON!) • https://amzn.to/3sOLGMv • Porter Cable Brad Nail Variety Pack: • https://amzn.to/30fVPFM • (These are affiliate links. When you shop through these links, we receive a small commission at NO EXTRA CHARGE TO YOU. We greatly appreciate the support!) • FOLLOW US ON INSTAGRAM: • / thehonestcarpenter • FOLLOW US ON LINKEDIN: • / thehonestcarpenter • Brad Nailers of one of the most universal tools you can own! But, they behave a little differently from other nailers. This video from The Honest Carpenter will show you 9 of the most common brad nail mistakes--and how to avoid them. • Brad nailers used to all be pneumatic. But tool manufacturers have recently begun producing BATTERY-POWERED BRAD NAILERS. These tools are a major time-saver, and extremely convenient because you don't have to lug around a compressor to use them. I've link my new PORTER CABLE BRAD NAILER above. • (Please note that brad nailers come in 18 gauge and 16 gauge sizes. For this video I've focused on the 18 gauge variety.) • 9 Brad Nail Mistakes: • #1: Overdriving--be sure your pressure isn't dialed up too high when shooting thin stock. The brad may punch straight through. • #2: Bruising Wood--too much pressure on the tip of your gun can also bruise wood. Don't press to hard, or bang nail . You can also soften the tip of the gun with painters tape. • #3: Too Much Nail--in general, you only need a nail about twice as long as your stock is thick. • #4: Spring Out--brads are somewhat flexible. They can change direction inside the wood grain and punch out through the side of your piece • #5: Fingers in Drive Path--don't keep your hands or fingers too close to the drive path of a brad nail. It may exit the wood an puncture your skin! • #6: Failure To Check Magazine--brad nails can separate in the top of the magazine, so be sure to check that all of the old nails are removed when changing nail belts. • #7: Steep Toenailing--brads are usually too flimsy for steep toenailing. Brads shot at more than 20 degree angles may skim off the surface of the wood and go flying. • #8: Don't Shoot Metal!--brads can't punch through metal effectively, so try to avoid shooting metal. • #9: Failure To Use Adhesive--brads aren't strong enough to hold things in place over time on their own. Use brads and adhesives together to keep projects securely fastened. • Thanks for watching 9 BRAD NAIL MISTAKES TO AVOID! Check out some of our other project videos below: • DIY Wood Repairs With Epoxy Glue: • • DIY Wood Repairs With Epoxy Glue • How To Remove Rivets: • • How To Remove Rivets...(Quick Guide T... • Be sure to visit us at The Honest Carpenter website! • www.thehonestcarpenter.com • (Raleigh, Durham, Chapel Hill, Apex, Cary, Wake Forest--North Carolina)
#############################
