Variocage Single Original Assembly Guide

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=d9yP58vmV00

Angus from MIMsafe UK shows how to assemble any of the Variocage Original Single Models, each instruction step is highlighted for ease of use. • ▬ Contents of this video ▬▬▬▬▬▬▬▬▬▬ • 0:00 - Introduction • 0:41 - Step 1 (Putting in the adjustment bolts on the floor panel.) • 02:00 - Step 2 (Getting the plastic stoppers and rubber gaskets onto the thinner sets of side bars.) • 03:52 - Step 3 (Putting the side bars together - ready to go onto the cage floor.) • 04:48 - Step 4 (Putting the sides onto the cage floor.) • 06:16 - Step 5 (Putting on the rear panel) • 06:36 - Step 6 (2 Black Bolts onto the inside of the rear panel.) • 07:36 - Step 7 (Bolting on the rear panel, 4 stainless bolts.) • 08:51 - Step 8 (Separating the roof and putting rubber stoppers into the roof panels to prevent noise while travelling.) • 09:47 - Step 9 (Putting the roof panels back together, ready to go onto the cage.) • 10:39 - Step 10 (Putting the roof onto the cage.) • 12.20 - Step 11 (2 x Stainless bolts through the rear of the roof into the side panels.) • 12:58 - Step 12 (Putting the adjustment bolts into the roof of the cage.) • 14:11 - Step 13 (Putting the door onto the cage) • 14:50 - Step 14 (Bolting the door onto the cage, 8 x Stainless bolts required) • 16:33 - Step 15 (Adjusting the depth to suit your car.) • 16:48 - Step 16 (Be careful shutting the boot when adjusting the depth) • 18:02 - Step 17 (Tighten up the depth adjustment bolts.) • 18:23 - Step 18 (Take it back out of the car to fit the rear escape hatch.) • 18:34 - Step 19 (Putting in the rubber gaskets to the rear escape hatch.) • 19:24 - Step 20 (Putting the escape hatch onto the cage.) • 19:49 - Step 21 (Putting in the red quick release toggles for the escape hatch.) • 20:37 - Step 22 (Load it into the boot space of the car.) • 21:07 - Step 23 (Inserting straps, ready to travel.)

#############################

New on site