TroyBilt Pressure Washer Pump Repair

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=e-ON4L2jQ4s

Wanted to share a quick fix on this TroyBilt pressure washer or (Power Washer) water inlet fitting. The repair can be temporary or permanent. This is powered by a 500 series Briggs Stratton, 2200 maximum PSI pump and 2.2 maximum gallons per minute output. The plastic water inlet coupling on the pump housing just cracked and we could not find the part locally Or online. • Not sure If we wanted to replace it with the original cheap part anyway and We had our project scheduled to pressure clean our sidewalk today, so we had to get creative to make this work. • We decided to take the plastic pipe off the pump housing and shave off the flange at the end to be able to insert a short hose held by a simple hose clamp. • Because the hose is slightly smaller, we shaved as much as possible off the plastic pipe. And to be able insert the hose with ease, we heated the hose with hot water. • This will soften it and make it expand as we insert it on the pipe. • We tightened the hose clamp. Before reinstalling it into the pump housing, we make sure the thread collar O ring is in place and in good condition. Reinstalled the pipe in the pump housing. and it’s all good to go!!! We will take our time looking for some threaded pipe and hose fitting to make this a permanent repair. • I hope this helps someone in a jam out there. • See RV DIY REPAIRS UPGRADES Playlist for more Videos; • • RV SLIDE OUT RAIL ALIGNMENT LUBING

#############################

New on site