BREATH Controller Settings

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=jpOMJvVGZPk

00:00 Intro • 00:42 Input Jack • 01:20 Breath Converter Menu • 02:03 Input Jack Setup • 02:40 Hardware Amplifier • 03:11 Software Amplifier • 05:19 Set All To Juzisound BC • 05:32 Set All To Yamaha BC-3(or compatible) • 06:02 How to start or stop the Breath Controller? • 06:23 Individual Part Control • Juzisound 2 allows the use of a BREATH controller. • The Breath Controller can be used to control the Sampler and an external device (a second MIDI cable is required for this). • BREATH Controller connector is on the rear end of the panel of the sampler. • The input has automatic detection of cable short circuits or other problems and will alert you with an appropriate • message. • We have complete control over:Jack Pin Configuration, Hardware Amplifier and Softwere Amplifier. • There's a whole section on the main menu for managing and performance tuning of the breath controller. • To get to this menu first enter the Main menu...then click on Breath Converter . • On the Breath Converter's menu there are also several submenus, each oriented to a particular aspect of the analog input settings. • The Sampler has predefined settings for the most commonly used Breath controllers: • You can Set All To Juzisaund BC ....or Set All To Yamaha BC-3(compatible).

#############################

New on site