Youtor
FreeCAD 10 simple 3D models part 19
>> YOUR LINK HERE: ___ http://youtube.com/watch?v=kGneROw5Z-o
FreeCAD 10 simple 3D models, part 19 • Welcome to the channel Miri tech workshop. • My name is Miro in this video there is an accelerated recording of the modeling of ten 3D models. During the entire process in FreeCAD, I primarily used Part Design and Sketcher. Some models may have been created using incorrect procedures, but some tips may inspire you. If you have ideas or constructive criticism, please share them in the comments. Have a nice day :) • 1. • I drew the spring in Part design. In the new sketch, I drew a circle that was a frofil for creating a helix. I defined the dimension from the central vertical axis. To create the spring, I used the function: Hellix and set the vise and pitch of the helix. I removed the straight ends in half so that I drew rectangles across the half, which I removed with the Pocket function. At the end, I adjusted the display settings so that I don't have graphic irregularities on the spring. Do not forget to set the Shape view parameter to flood data, because when you model the complexity of the component, the program will require more of the computer to render the component. • 2. • I drew a 3D model of the body in Part design. I proceeded by creating a new sketch and drawing a circle Circle and using Polyline I drew a shape in the upper part and I used Trim edge to blend part of the circle. I used the Pad function to create 3D. I selected the area and created a new sketch on which I drew an exciting opening - a circle. I used Pocket to remove the material so that a hole was created. I used the Polar pattern for even spacing when creating new holes around the central axis. We can also see the color change at the end of the video. • 3. • To begin with, I chose Part design and created a new sketch, selected a plane. I drew the shape of the part, but only the part that I then rotated around the axis. I defined the necessary dimensions and used various connections. If I no longer had any degrees of freedom, I closed the sketch and used the Revolution function. I marked the edges by clicking on the bowl, but I also held down the CTRL key. Next, I gave them a radius and changed the color. We can see the bad rendering of the shape that I wanted to improve in the last step by changing the value: Shape view If possible, it is a good idea to overwrite the value for the flood, because in future modeling of complex shapes, we can extend the time of rendering the part and the program can work slower.. • • 1. 3D model. 00:00 • 2. 3D model. 02:35 • 3. 3D model. 04:43 • 4. 3D model. 08:02 • 5. 3D model. 10:29 • 6. 3D model. 13:09 • 7. 3D model. 15:20 • 8. 3D model. 17:26 • 9. 3D model. 19:37 • 10. 3D model. 21:21 • Vitajte na kanáli Miri tech workshop. Moje meno je Miro v tomto videu je zrychleny zaznam z modelovania desiatich 3D modelov. Počas celého procesu vo FreeCAD som primárne využíval Part Design a Sketcher. Niektoré modely mohli byť vytvorené pomocou nesprávnych postupov ale niektore tipy vas mozu inspirovat. Ak máte nápady alebo konštruktívnu kritiku, podeľte sa o ne v komentároch. • Prajem pekny den :) • #freecad #partdesign #3dmodeling #sketch
#############################
