Section 18 ESteps and Flow Rate

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=lH-RrjtiC8M

In this video I go over Section 1.8 of Luke's Guide, Esteps and Flow Rate. I have updated the Math in the examples below. Luke now uses a .8 wall on the test cube as it's more accurate. • 🛑Subscribe for more: https://www.YouTube.com/theedgeoftech... • 🐱‍🏍Share this video with a friend: • • Section 1.8 ESteps and Flow Rate • 💾 Share this channel with a friend: • / @theedgeoftech • EStep Calculation: • 100 (commanded Steps) divided by 98 (actual steps taken) = 1.02 • 1.02 x 93 (Current ESteps) = 94.86 • 95. is your new ESteps if you round up • Flow Rate Calculation: • Value of all 8 measurements divided by 8 = Average Measurement. • .80 divided by average measurement multiplied by 100 = New Flow Rate. • Example: • .78+.80+.76+.79.+.80+.81+.75+.78 - 6.27 Equals Total Walls Measured • 6.27/8=.783 - Total Walls Measured divided by 8 (8=total measurements taken, 2 on each side of the cube) • .8/.783 = 1.02 - Wall thickness (.8) divided by Average of Total Walls Measured (.783) • 1.02x100=102. = 102 is the new flow rate. • Luke's Short throw Calibration Test Cube: https://www.thingiverse.com/thing:322... • Luke's Help Guide • https://support.th3dstudio.com/hc/en-... • Disclaimer: Some of these links go to one of my websites and some are affiliate links where I'll earn a small commission if you make a purchase at no additional cost to you. As an Amazon Associate I earn from qualifying purchases. • Ender 3 V2 Amazon: https://amzn.to/2OA9bug • Code: 07ZGQI2J to save some money! • Ender 3 V2 Amazon:https://amzn.to/3qRzLwb • Code: 07GZXYYD to save some money! • Decent Caliper for 3D Printing: https://amzn.to/3elcw8N • Ender 3 Pro on Amazon: https://amzn.to/3ak9BtS • Ender 3 direct from Creality: • Ender 3: https://www.creality3dofficial.com/co... • Ender 3 Pro: https://www.creality3dofficial.com/co... • The Edge of Tech Amazon Affiliate Store Front: https://www.amazon.com/shop/theedgeof... • Support the channel through these links! • PayPal • https://paypal.me/theedgeoftech • Patreon • / theedgeoftech • Watch next – Luke Hatfields Help Guide Playlist - • Luke Hatfield's Help Guide for Creali... • Recommended Playlist – Community Showcase - • Community Showcase • Let’s connect: • Instagram: / theedgeoftech • Twitter: / theedgeofteck • Facebook: www.facebook.com/TheEdgeofTechOfficial • ----------------------------------------Credits----------------------------------------------------------- • Music by Wicked Realm • Album - No More Fairy Tales • Song - Feed • / @wickedrealm5507

#############################

New on site