Connect Up To 992 Servos To An Arduino Using I2C

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=mQK3Scp3Qls

In this tutorial, I’m going to be showing you how to connect up to 992 servos to an Arduino by using these 16 channel PCA9685 PWM drivers which are controlled over I2C. Each one of these boards can drive up to 16 servos or PWM outputs and you can chain up to 62 of them together, meaning that you could drive up to 992 servos - all controlled by two pins on a single Arduino. • Written Tutorial With Code Circuits - https://www.the-diy-life.com/connect-... • Components Required • Arduino Uno - https://amzn.to/3dbmMyZ • 16 Channel PWM Driver - https://amzn.to/3fnQ6ZG • Micro Servos - https://amzn.to/3d9YAgf • 5V 5A Power Supply - https://amzn.to/2ynEgJH • Ribbon Cable - https://amzn.to/3bbX78I • Female Pin Header - https://amzn.to/3b9TO1N • Male Pin Header - https://amzn.to/2VrQvML • If you've got any Tutorial requests or suggestions, let me know in the comments section below. I'm always looking for suggestions.

#############################

New on site