Cisco 4G LTE Router Configuration How To

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=oZR5ecgPXP0

In this video I take you though the configuration of a cellular interface on a Cisco router. This process will be similar on most Cisco 4G interface cards however this particular setup was done on an IR829 Industrial router. After configuring I also show some of the troubleshooting commands to review signal strength, verify the carrier, etc on this system. • I suggest this document from Cisco to understand the configuration in more depth: https://www.cisco.com/c/en/us/td/docs... • The applicable configuration: • controller Cellular 1 • description AT T • lte sim data-profile 1 attach-profile 1 • no lte gps enable • lte modem link-recovery rssi onset-threshold -110 • lte modem link-recovery monitor-timer 20 • lte modem link-recovery wait-timer 10 • lte modem link-recovery debounce-count 6 • interface Cellular1/0 • ip address negotiated • encapsulation slip • load-interval 30 • dialer in-band • dialer string lte • dialer-group 1 • no peer default ip address • routing dynamic • dialer-list 1 protocol ip permit • ip route 0.0.0.0 0.0.0.0 Cellular1/0 • Great Study materials • CCNA: https://amzn.to/2QGwrnu • CCNP: https://amzn.to/35fpP4Q • • #Cisco #IoT #Router

#############################

New on site