Brushless Motors Encoder Setup and Calibration Torque Speed Verified

YOUR LINK HERE:

http://youtube.com/watch?v=q0qURR0-ca4

This video demonstrates how to set up and calibrate your incremental Encoder with SOLO to control Torque, Speed, and Position of Brushless motors of any kind ( BLDC, PMSM, and EC coreless). • The video starts by showing the correct connection for Encoder wires and then it shows how the 3 phase motor wires' should be connected and verified by checking the Torque and Speed behavior. • To learn more you can visit: • https://www.solomotorcontrollers.com/... • Order one: • https://www.solomotorcontrollers.com/... • The link to Motion Terminal: • https://www.solomotorcontrollers.com/... • 0:00 intro • 0:56 Incremental Encoder Wires Connection • 2:14 Encoder Connection Verification in Motion Terminal • 4:39 Motor wires combination check and Initial setups • 7:04 Encoder Calibration for a candidate of wirings • 8:55 The behaviour of a correct combination • 9:40 Torque loop test on a working combination • 10:55 Speed loop test on a working combination • #BLDC #servoDrive #PMSM #EC_Coreless #Torque #Speed

#############################

New on site