How to use Blue light remote control Duplicator

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=uI5Xq8nZQSw

Blue Light Remote Control Duplicator From: • https://goo.gl/kJkQRU • Link from DE: https://www.amazon.de/dp/B09GF789Q8 • • how to use： • Step 1 – delete the existing code of our remote duplicator • • 1) Press and Hold “A” and “B” buttons together - Led will flash 3 times • Keep holding “A” button and release “B” button • 2) Keep holding “A” button and push “B” button 3 times, Led will start flashing Non-stop • (Please note: during the deletion procedure, make sure to keep the “A” button pressed the whole time) • Now press any key on the remote control, LED lights are not bright, so delete code success; if you press the button LED lamp is lit, indicating that the original code is not deleted! • Step 2 - clone your original remote • • 1) Put both remotes into “back to back” position. Make sure they have direct contact. • Or the two remote controls should be placed as closely as possible (put the two remote controls on the desktop side by side with zero distance) • • 2) Press and hold one button on your original remote and one button on your clone remote. • Keep holding until LED will make 2 blinks （Note: LED 2 blinks not to release button） • Then 3 blinks then into steady and you have successfully cloned. ( other buttons follow the same above operation) • • If for some reason the clone does not go further then 2 blinks , it means the signal does not go through, please shift the remote slowly up and down until you get the point where it will go through. • For the presence of noise, it should avoid interference to operate, If the copy is not successful, it should recopy after clearing code.

#############################

New on site