Youtor
TEC2000 Fuel Injector Cleaner Jak skutecznie dodatek do benzyny czyści wtryskiwacze wtryski
>> YOUR LINK HERE: ___ http://youtube.com/watch?v=wAeQyYbp7rQ
Subscribe: https://www.youtube.com/c/PiotrTester... • Contact: [email protected] • Injector Cleaning Attachment Test - # Tec2000 Fuel #Injector #Cleaner • Cleans fuel injectors, restores proper atomization of injected fuel, maximizes drive efficiency • Facilitates cold start • Significantly reduces black smoke from the exhaust system and reduces harmful exhaust emissions • Extends the life of the injectors and fuel pump, thanks to the special lubricating components included • Significantly improves combustion economics and increases engine power • Mutes and smoothes engine idling • TEC2000 Fuel Injector Cleaner How to use? • Disconnect the fuel feed and return lines from the strip • In place of the factory-made cables, connect the service lines of the injector cleaning machine and put their free ends in the box with the TEC-2000 Fuel Injector Cleaner • Start the engine, from now on the engine runs on TEC-2000, one can, ie 375 ml, is enough for about 20 minutes of work. • When the can is empty, turn the engine off • Unclip the service lines • Connect the factory wires • Cleaning is finished, however, if the effect is partial or the injectors are particularly heavily contaminated, it is recommended to repeat the whole operation. • Alternatively, the formulation may be administered by filling the fuel filter tank in vehicles where it is justified by easy access to the filter. • After completing the above steps, start the engine at idle speed for about 20 minutes. • Last solution if none of the above variants is impossible to apply. Insert the end of the suction pipe from the fuel pump of the vehicle into the TEC-2000 Fuel Injector Cleaner box, while the tank return pipe should also be inserted into the can. The motor should run until the can contents are almost empty. In order to achieve better results in high mileage engines, we recommend prolonging the procedure for another 20 minutes, using an additional can of 375 ml TEC-2000 Fuel Injector Cleaner. • How was the contaminated oil in the test tube? • It is overworked mineral oil from diesel, in which I dissolved the towot. Then the oil was heated up until it ignited. This procedure was repeated 5 times. In addition, I added lithium grease, ceramic grease, motodrite and addition of MoS2. The resulting oil is difficult to wash. • In each sample there is 10ml of contaminated oil (I have a large supply). The oil is distributed throughout the sample. Then the sample is tested on a closed circuit machine - at the end there is a means for rinsing injections / injectors (description in the film). Machine working time 1 minute. • Then it evaluates the condition of the test tube. The speed with which the tested fuel additive cleanses the tube should also be assessed. • • Piotr Tester combination: • https://uszlachetniacze.blogspot.com/... • If you want to support my channel: paypal.me/PiotrTester • The addition to the oil for the test was sent by Mr Sławomir. Thank you • http://tec2000.pl/
#############################
