Dead Load in Girder Beam Example Structural Design amp Loading

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=xOlHmiSrOZs

http://goo.gl/VQHEtZ for more FREE video tutorials covering Structural Design Loading • The objective of this video is to determine dead loads actions on girders B2 B3 in KN/m based on the data available overviewed in section 1.14 of ‘Introduction to the Problem’. By now, it is clear the load acts on the slab follows the two way slabs load paths for the transmission of load from slabs to beam to girder to column to the ground. The video, after the illustration of schematic diagram, talks about the tributary area through which the loads are basically transmitted. • Moving on, the video step by step shows the calculation of the permanent actions working from slab above for two way slabs load paths. Necessary formula has introduced and earlier videos reference is used to show the entire calculation. Subsequently, the video shows the calculation of self-weight as before and finally by adding the self-weight value with the calculated value of permanent actions working from slab above, the dead load actions on girders B2 B3 in KN/m have been determined.

#############################

New on site