youtor.org
#############################
Video Source: www.youtube.com/watch?v=9ONQfTEgDes
DIY printed concrete video from A to Z • Step-by-step instructions EXPERIMENT • I welcome everyone! Dear guests and subscribers! • In this video I will show how I use a cement-based grout, frost-resistant, moisture-resistant. • To begin with, we prepare the wall, namely, we get rid of dirt and moss if it is present, the next step we get is priming the walls. • Primed with a concentrate, diluting the concentrate one to four, after the primer has dried, we fasten the mesh, the mesh may be different and the mesh must be attached to the wall or to the base that you will be decorating. • The grid is attached to the smarts with self-tapping screws, after which we attach the beacons to the width of the rule. • Next, stir the tile glue with the addition of fiber according to the instructions, after which throw in 1 thin layer, throw a layer so that it covers the mesh and adjoins the wall itself, after which I throw in the main layer of glue and take it out by the rule along the lighthouses without waiting for the tile glue to dry. • Immediately I throw in (apply) frost-resistant moisture-resistant grout. • Grout is sold in hardware stores, it is in different colors. • I apply three colors, the first layer is base beige, then brown and the third white, so I apply in this order twice immediately without waiting for the tile glue to dry. • Then I stamp it with a polyurethane stamp for concrete, which I made myself. • When I stamped the drawing, I spray it with a little bit of water, but without fanaticism, thereby the grout penetrates into the solution itself. • The next day, I brush off the grout for joints that has not been saturated with a hard brush, after which I primed it with a second layer of deep penetration primer, thereby fixing the grout for the joints. • After the primer has dried, I apply a tint varnish, acrylic varnish for outdoor use, it is available in different colors, it is sold in hardware stores. • After the varnish has dried, I apply white facade paint with a hard brush along the edge of the pebbles, and this is where the decoration is over. This effect turned out) Thank you all! If you have any questions, please ask in the comments, I will be happy to answer all your questions. With respect, Nicholai! • ✔How to make a stamp for concrete with your own hands with handles • Как сделать штамп для бетона своими р... • ✔How to paint a decorative stone from A to Z • Как покрасить декоративный камень от ... • ✔How to paint a decorative stone with a primer • Как покрасить грунтовкой Декоративный... • ✔Painting decorative stone with a primer with colors • Покраска декоративного камня грунтовк... • ✔ DIY concrete stamp • Как сделать формы - штампы силиконовы... • 💎Subscribe to the channel / @nikolapiterr
#############################
New on site
