Quickie Split Bushing

############################# Video Source: www.youtube.com/watch?v=KuCOnyw6IUQ

Needed to build a split bushing to mount a newly acquired die grinder inside my biggest Aloris boring bar holder. • Material is 6061 T-6 aluminum, ~1 1/2 rough OD. • Machine is a PM1660 manual engine lathe, ~18 swing over the bed 60 between centers. • Die Grinder is from Enco: http://www.use-enco.com/CGI/INSRIT?PM... • Tools used: • Turning: • Insert = MaxPro CNMG 431 PF, uncoated high polish surface, with high positive cutting geometry for aluminum finishing. • Toolholder = Kennametal MCLNR 16-4D • Drilling: • Small Drill = 1/2 Cobalt Screw Machine Drill • Big Drill = 1 3/16 HSS Morse Taper Shank Drill • Bandsaw = Ellis 1600 Portable Mitering Band Saw • Speeds Feeds: • Turning Small Drilling = 600 RPM • Big Drilling = 275 RPM • Fashions by Carhartt Old Navy. • Hat by Otto. • Shoes by New Balance. • Body by Burrito Tater Tot, with special considerations from BBQ Pork. • Warped Sense of Humor Provided by The Internets™ in cooperation with my Family Friends. • No animals were harmed during the making of this video, but some were consumed just before, and probably right after too. • Not responsible for typographical errors, your mileage my vary, void where prohibited, fat man is actually scruffier than he appears, do not induce vomiting if accidentally swallowed, always use in accordance with your doctor's advice, may cause irritation when applied to tender areas, if effects last longer than four hours, just wait longer. • Bumper music is The Real Folk Blues performed by Sapphire. • For more information about the AirBase product and other projects we've got going on in the shop, • check out our website at http://www.logic-industries.com

#############################

New on site