How to Replace Crankshaft Position Sensor 19992006 Chevrolet Silverado 1500

############################# Video Source: www.youtube.com/watch?v=T87BUTMUy_c

Buy Now! • New Crankshaft Position Sensor from 1AAuto.com http://1aau.to/id/1AECS00002 • This video shows you how to install a new crankshaft position sensor from TRQ on your 1999-2006 Chevrolet Silverado 1500. The crankshaft position sensor is an important component of any electronically controlled ignition system. The sensor provides the computer with data about the position of the crank shaft to properly adjust ignition timing. If the sensor in your vehicle is broken or malfunctioning, you may suffer poor performance, or get a check engine light. • Once the new sensor is installed, you perform the following relearn procedure: • 1. Accelerate to wide open throttle (WOT). • 2. Release throttle when fuel cut-off occurs. • 3. Engine should not accelerate beyond calibrated RPM value. • 4. Release throttle immediately if value is exceeded. • 5. Block drive wheels. • 6. Set parking brake. • 7. DO NOT apply brake pedal. • 8. Cycle ignition from OFF to ON. • 9. Apply and hold brake pedal. • 10. Start and idle engine. • 11. Turn A/C OFF. • 12. Vehicle must remain in Park or Neutral. • 13. The scan tool monitors certain component signals to determine if all the conditions are met to continue with the procedure. The scan tool only displays the condition that inhibits the procedure. The scan tool monitors the following components: • Crankshaft position (CKP) sensors activity—If there is a CKP sensor condition, refer to the applicable DTC that set. • Camshaft position (CMP) sensor activity—If there is a CMP sensor condition, refer to the applicable DTC that set. • Engine coolant temperature (ECT)—If the engine coolant temperature is not warm enough, idle the engine until the engine coolant temperature reaches the correct temperature. • Enable the crankshaft position system variation learn procedure with the scan tool. • This repair was done on a 2004 Chevrolet Silverado 1500 Base 4.3L Extended Cab Pickup 4-Door RWD Automatic and the process should be similar on the following vehicles: • 1999 Chevrolet Silverado 1500 • 2000 Chevrolet Silverado 1500 • 2001 Chevrolet Silverado 1500 • 2002 Chevrolet Silverado 1500 • 2003 Chevrolet Silverado 1500 • 2004 Chevrolet Silverado 1500 • 2005 Chevrolet Silverado 1500 • 2006 Chevrolet Silverado 1500 • Tools you will need: • • 8mm Socket http://1aau.to/obMW/1AXAA00017 • • Ratchet http://1aau.to/ocfA/1AXAA00016 • • Gloves http://1aau.to/obhV/1AXSS00048 • • Safety Glasses • • Scan Tool • Subscribe: / @trq • ⚠ DISCLAIMER: • While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

#############################

New on site