Push Button Servo Control using DCC EX

############################# Video Source: www.youtube.com/watch?v=kz3zgntkIJM

This is part two in my series on Servo Control using DCC EX. This is to show programming and operation of servo control for turnouts using push button control. • Link to my previous video on the initial setup of DCC EX with a PCA9685 to control ServoTurnouts: • • DCC EX Turnout Control OLD VERSION - ... • Link to the DCC EX website showing the usable pins on an Arduino Mega: • https://dcc-ex.com/reference/hardware... • Link to the files used for this demo. NOTE...This is ONLY the 3 folders created for the project, NOT the entire Command Station folder. Copy these into your command station folder THEN open Arduino IDE, they should be there. • https://www.dropbox.com/scl/fo/ohtzgh... • Link to my video on using PCA9685 to control LED's: • COMING SOON • Link to my video on setting up DCC EX with I/O Expanders: • COMING SOON • 0:00 Start • 1:57 Setting Up Latching Switching • 5:11 Using Arduino IDE and Defining Turnouts • 7:30 Defining Aliases • 9:37 Writing the Sequences and Uploading the Sketch • 13:02 Latching Switch Demo • 15:04 Setting Up Momentary Switches • 17:22 Using Arduino IDE and Defining Turnouts • 19:26 Defining Aliases • 23:16 Writing the Sequences and Uploading the Sketch • 34:33 Momentary Switch Demo • 36:54 Demo buttons with no Delay • 37:54 Routes and Automations

#############################

New on site