Limit Switches Installation to CNC machine

############################# Video Source: www.youtube.com/watch?v=o96A11vivN0

GRBL setting for my machine is: • $0=10 (step pulse, usec) • $1=25 (step idle delay, msec) • $2=0 (step port invert mask:00000000) • $3=3 (dir port invert mask:00000011) • $4=0 (step enable invert, bool) • $5=0 (limit pins invert, bool) • $6=0 (probe pin invert, bool) • $10=3 (status report mask:00000011) • $11=0.010 (junction deviation, mm) • $12=0.002 (arc tolerance, mm) • $13=0 (report inches, bool) • $20=1 (soft limits, bool) • $21=1 (hard limits, bool) • $22=1 (homing cycle, bool) • $23=0 (homing dir invert mask:00000000) • $24=25.000 (homing feed, mm/min) • $25=500.000 (homing seek, mm/min) • $26=25 (homing debounce, msec) • $27=1.000 (homing pull-off, mm) • $100=399.000 (x, step/mm) • $101=399.000 (y, step/mm) • $102=399.000 (z, step/mm) • $110=500.000 (x max rate, mm/min) • $111=500.000 (y max rate, mm/min) • $112=500.000 (z max rate, mm/min) • $120=100.000 (x accel, mm/sec^2) • $121=100.000 (y accel, mm/sec^2) • $122=100.000 (z accel, mm/sec^2) • $130=235.000 (x max travel, mm) • $131=145.000 (y max travel, mm) • $132=60.000 (z max travel, mm) • ok • host for downloads: https://yadi.sk/d/oEE8svUX3QAnTd

#############################

New on site